Am looking to get some for my CBR NC29. Will the fairing need to be drilled? Anyone have any pics of their bike with bungs on it? thanks! :)

Yes they will....

And there are loads of pics in the gallery

drill the holes the same + 3mm diameter of the widest part of the bungs. = easy to remove/fit panels.

leopard_pagan wrote:drill the holes the same + 3mm diameter of the widest part of the bungs. = easy to remove/fit panels.

Hey many thanks for that ! Will get my fella to give me a hand as he did them on my last bike!!

Honda_Star wrote:Am looking to get some for my CBR NC29. Will the fairing need to be drilled? Anyone have any pics of their bike with bungs on it? thanks! :)

Here is dimension I have on my bike.
http://img.moto.kiev.ua/thumbcache/5957 ... 642737.jpg

and i bet you have to un-bolt them every time you want to remove the side panels Parus?
mine started out like that, i do a lot of work on my bike and that became a hindrance esp the RHS one as you have to fit a spacer in-between the frame and engine.. while you cant see or get your fingers in to hold it! in the end i had them re-cut bigger. have not un-bolted them since.

leopard_pagan wrote:and i bet you have to un-bolt them every time you want to remove the side panels Parus?
mine started out like that, i do a lot of work on my bike and that became a hindrance esp the RHS one as you have to fit a spacer in-between the frame and engine.. while you cant see or get your fingers in to hold it! in the end i had them re-cut bigger. have not un-bolted them since.

Yes, you're absolutely right. I was able to make bigger holes,but with these ones bungs fixed side panel and don't allow then to "dangle". But I need to remove them all the time I need to make something.