exhaust ID
Posted: Wed Feb 18, 2009 1:42 pm
can anyone tell me what make this is.
HAHAHAHAHAHAHAAHAHAH!!
No I can not LOL
Page 1 of 1
Re: exhaust ID
Posted: Wed Feb 18, 2009 1:45 pm
Re: exhaust ID
Posted: Wed Feb 18, 2009 1:58 pm
WOW!!! It looks like you found a hens tooth amongst the rocking-horse poo, that's HRC that is...
LOL, only kidding mate, there's no pic showing
LOL, only kidding mate, there's no pic showing
Re: exhaust ID
Posted: Wed Feb 18, 2009 2:33 pm
did try fu$$ing computers.
will try again later when i cool down.
will try again later when i cool down.
Re: exhaust ID
Posted: Wed Feb 18, 2009 9:34 pm
Not sure about the sections after the original front down pipes. Another look at them
says to me it's an halfsystem with spring-fitment connection, and the curve at the last section
unveals maybe it's a highmount.. :)
By any chance, if you can take a measurement of the outer-diameter (OD) and inner-diameter (ID),
maybe that helps you in finding your answer by verifying with exhaust systems of other members here?
My 2 cents? So far I believe it's not hrc, yammymoto, ethos, moriwaki, tsr, jha, sansei.
says to me it's an halfsystem with spring-fitment connection, and the curve at the last section
unveals maybe it's a highmount.. :)
By any chance, if you can take a measurement of the outer-diameter (OD) and inner-diameter (ID),
maybe that helps you in finding your answer by verifying with exhaust systems of other members here?
My 2 cents? So far I believe it's not hrc, yammymoto, ethos, moriwaki, tsr, jha, sansei.