Hi chaps,

Forgive the rookie question, but I've had my wheels off to be repowdered and noticed a lot of grease on the rear hub, and wheel carrier.

Question the first...
Does this need to be refreshed (I've not done in 5000km/ 6years and suspect this is the factory issued gunk)

Question the second...
I would say whoever schmoo'ed it up before me was very liberal... Right? Wrong?

Final question...
If I need to regressed, will normal lithium based grease do, or do I need high temp stuff??

Thanks as always!
[emoji2] [emoji106]

Sent from my Swift 2 X using Tapatalk

Looks like copper grease? Just to stop the wheel corroding and sticking on.

Leave it alone

Cheers

Ian

Morespeedvicar wrote:Looks like copper grease? Just to stop the wheel corroding and sticking on.

Leave it alone

Cheers

Ian

Cheers Ian!!

Sent from my Swift 2 X using Tapatalk

Looks like the bike's PO suffered from "stuck rear wheel" syndrome and didn't want it happening again!

Ciao,