hi guys is this possible to do. has any one tried with success or failure?

any advice or ideas gladly received

thanks

I don't see the point personally. It's not as if the nc24 rear end gives you any advantages: it will be heavier and has a skinny rear tyre.

What model fzr,
I've put a 30 arm on a 3TJ.

I will let you know as I have all the bits

I'm doing it purely for cosmetic reasons

Plus I managed to pick up the Complete Rear (With nearly new tyre) for only £27 Delivered

Fitting it to a 3en1

Haven't done any measuring yet though (Hope not too much work)

New Swing Arm Pivot Bolts will need to be Machined

Originals



Original Center Mount