Does anyone know if the carburettor rubbers from either an NC23 Aero or an NC29 Gullarm will fit properly on an NC23 Tri-Arm? I need to get a set by this weekend and the specific Tri-Arm ones seem to be a bit thin on the ground, I have seen a couple of other sets on eBay for the aforementioned models but wasn't sure if they'd be the same size or not.

aero yes...29 unsure,
stimpy

I have plenty of good used NC29 and NC23 Tri Arm original Honda carb inlet rubbers in stock @ £2.50 each inc VAT.

UK delivery on up to 4 units - £3

Paypal is fine as per email below: