ok.so ive got the 35 linkage triangle in but it still sits low.can i drill new holes in dog bones ot do u elongigate the original holes?? any advice appreciated..

You needed to get the NC35 dogbone, not the triangle...


pikey method - weld up the old holes and drill new ones...

ah.sorry i meant the dog bones/triangle/linkage. cheers for reply

Is your shock knackered by anychance? Setup properly?

These bikes don't sit super high anyway.. have you measured where it is sitting and compared it to a properly setup bike yet / factory book or are you just guessing it is sitting too low?

shock was rebuilt by moto pro before i had bike.i havent fiddled with it and dont want to until i have/need to.i have 30 linkage in my spares box(previous owner sed 35 linkage is on it)but looks to be sitting low...also im 13-14 stone so it will probally need raising