my 3tj 600
Posted: Sat May 25, 2013 5:09 pm
well as it was a nice day i thought i would get out the big hammer and the roll of ducktape.
the job was quite simple, took a few hours but i don't always rush, got to make time for tea and a smoke
so its in place but thats it i did have the carbs, airbox and tank on earlier and they will do
i will sort out cdi over the weekend the 600 loom is sat there.
its not the standard pipe so i might have to cut it and reweld that but i will look closer at that once i have bolted the down pipes up.
if i get my finger out i'm hoping to get it fired up on monday, if it was good enough for joey D then it will do for me, some nice quiet back lanes round here, you have got to road test your track bike
the job was quite simple, took a few hours but i don't always rush, got to make time for tea and a smoke
so its in place but thats it i did have the carbs, airbox and tank on earlier and they will do
i will sort out cdi over the weekend the 600 loom is sat there. its not the standard pipe so i might have to cut it and reweld that but i will look closer at that once i have bolted the down pipes up.
if i get my finger out i'm hoping to get it fired up on monday, if it was good enough for joey D then it will do for me, some nice quiet back lanes round here, you have got to road test your track bike