Hello.

I have an nc24 that is my current project, however the bloke I got it off has left the electrics in a bit of a state.

I, am useless with electrics. While I could probably figure it all out eventually, I was wondering if there is anyone in the lincoln area that wouldn't mind coming and helping out.

All the wiring is present as far as I know, but it needs properly routing and labelling so I know what should go where when I put it back together. Would also be nice to have my ignition barrel near the handle bars too, not dangling over the rear wheel haha!

Any help is appreciated, an I'm sure I can part with a bit of cash to anyone who can help.

Thanks!