• Gear selector shaft seal

Posted: **Wed Jan 16, 2013 8:23 pm**

Does anyone know if you can change the gear selector shaft seal (on a nc23) without stripping the engine down and removing the shaft?
Cheers

Posted: **Thu Jan 17, 2013 9:26 pm**

I dont have a cbr BUT if you can see the seal you can replace it.

Posted: **Thu Jan 17, 2013 10:20 pm**

ah cool I thought that was the case

Posted: **Sat Jan 19, 2013 8:04 pm**

Ive done by gently tapping something sharp through the seal and flicking it out, careful as there is usually a small 'c' clip behind.

Posted: **Sat Jan 19, 2013 8:41 pm**

Yea I've done it now, used a self tapper, screwed it in then just pulled it out with a pair of pliers, then tapped the new on in

Gear selector shaft seal