Page 1 of 1
3tj hugger
Posted: Sat Nov 24, 2012 7:52 pm
by tattytom
hi there everyone just got a fzr400rr tosay with the help of a fellow member loveing the bike
just wanting to know what modifications do i have to do to get a thundercat rear hugger to fit ?
cheers tom
Re: 3tj hugger
Posted: Sun Nov 25, 2012 1:34 am
by Evilchicken0
There isn't a hugger that's made for these bikes, if you have a look under it's tail you'll see part of the undertray comes down a bit, that's you lot I'm affraid.
I recognise the bike, it's missing the P clips that hold the front brake hoses, apart from that it looked to be pretty much together. So - lube the chain, check the oil and brake fluid ... put a bit of petrol in there and you're good
Re: 3tj hugger
Posted: Sun Nov 25, 2012 10:45 am
by tattytom
hey yeah ino one wasnt made but i have done abit of research and a thundercat rear hugger can be "persuaded" to fit
and cheers ill get that on my to do list
also i bought it off a freind of a member so the owner might actually have an account not sure to be honest
cheers tom
Re: 3tj hugger
Posted: Sun Nov 25, 2012 12:20 pm
by Evilchicken0
You can try to get it to fit but I think you'll need to cut the existing under tray and the swing arms are subtlety different so you end up with a lot of work for not much gain.
If you've got a nice shock you could put a sock on it but then again if you keep it clean it should be fine.
Re: 3tj hugger
Posted: Mon Nov 26, 2012 5:01 pm
by dobbslc
Was that the bike on ebay? it looks very nice and I was tempted........
Welcome to the forum.
Re: 3tj hugger
Posted: Mon Nov 26, 2012 5:37 pm
by Evilchicken0
Re: 3tj hugger
Posted: Tue Nov 27, 2012 10:12 pm
by tattytom
hi there thank your for the welcome
and yes that is the bike :) :)