I fitted some chear LED t5 bulbd that blew - well melted in the side light bulb holders. I have just purchased new LEDs from Crazy LED's which i have just fitted and for some reason they are not working.

all was working fine with them before fitting the ceap LEDs.

Anybody got any advise on where to start looking for the fault.

Thanks

i did exactly the same thing mate but the ones from crazyled's worked fine. The connection was a bit funny - needed a bit of wiggling around to get it right.

I also found they worked better if you bend the pins on the T5's around each side of the bottom of the LED.

Have you tried getting a multimeter on the connections in the bulb holder? Just to confirm there is no power coming through.

not yet but hoping to have a play with the new LED's and a meter to check what happened. Hopefully will be all sorted very soon