Page 1 of 1
RPM Signal Wire
Posted: Thu Jun 21, 2012 10:11 pm
by g1b50n
Ive fitted a Datatool gear indicator to my NC30, for the rev signal ive tapped into the YELLOW and GREEN wire that goes into the back of the rev counter from the CDI for a rev signal. Is this correct? Thanks for help in advance.
Re: RPM Signal Wire
Posted: Thu Jun 21, 2012 10:16 pm
by thunderace
Did you throw the Datatool destructions straight in the bin then?
Re: RPM Signal Wire
Posted: Thu Jun 21, 2012 10:25 pm
by g1b50n
[quote="thunderace"]Did you throw the Datatool destructions straight in the bin then?[/quote
Why's that?