Page 1 of 1
More Chinese copies
Posted: Wed May 23, 2012 7:48 pm
by Davez29
I think soon the Chinese will be doing the rest of the nc29, I found some OEM style footpegs today, very cheap and cheerful no doubt. How do they send them all this way at that price?
http://www.ebay.co.uk/itm/Honda-CBR250- ... 4ab5b0c371
Re: More Chinese copies
Posted: Wed May 23, 2012 10:21 pm
by cbr400rrn
Must only cost them only a few pence (or renminbi) to make if they can post them for that price
Re: More Chinese copies
Posted: Wed May 23, 2012 10:33 pm
by Davez29
Well I have bought a set, will let me keep the originals from wearing down any further, the left one in particular is very slippy in the wet. Even if I can just use the rubber bits somehow. Honda prices for these just keep going up, I think its around £50 each now.. Amazing.
Re: More Chinese copies
Posted: Thu May 24, 2012 10:26 pm
by cbr400rrn
Durka Durka wrote:Well I have bought a set, will let me keep the originals from wearing down any further, the left one in particular is very slippy in the wet. Even if I can just use the rubber bits somehow. Honda prices for these just keep going up, I think its around £50 each now.. Amazing.
£50

the robbing gets.
Let me know if they are ok as i do need some really
Re: More Chinese copies
Posted: Thu May 24, 2012 10:55 pm
by Davez29
Will do, apperently they are despatched very quickly after my order. Just interested what you get for £6, will hit em with a hammer, do some Brainiac testing on them.
Re: More Chinese copies
Posted: Fri May 25, 2012 8:17 pm
by cbr400rrn
Durka Durka wrote:Will do some Brainiac testing on them.
Caught you watching kids T.V

It is funny though
Re: More Chinese copies
Posted: Thu Jun 07, 2012 4:06 pm
by Davez29
Well they came today via recorded delivery, got to say they look fine. I threw them about tried to pull the rubber off but nope, its looking good. Some minor difference to OEM but hard to spot. The hero blobs dont look like the OEM ones. great if you want standard looking without Honda prices.
heres a piccy or two..

Re: More Chinese copies
Posted: Wed Jul 25, 2012 9:20 am
by Davez29
Just a quick update on these. I finally fitted them but used the original spring and pins due to the spring being not bent the correct way and the pin was at a half inch longer than needed. They would have worked but looked a bit odd. The pegs themselves are fine and look a tad better not being worn. Used for the last three weeks no problems.
Re: More Chinese copies
Posted: Sun Jul 29, 2012 9:47 am
by royster81
let see some pictures of these wee beasties fitted then.
Re: More Chinese copies
Posted: Thu Aug 02, 2012 2:28 am
by Davez29
royster81 wrote:let see some pictures of these wee beasties fitted then.
one of the wee beasties.
http://flic.kr/p/cHAgqm