Just ordered the adapter kit for my rvf and the left hand side doesn't fit, too big. It does say RVF and kit 19 on the invoice.
The nut is 24mm and the adapter is few mm bigger, anyone else ordered the kit and was it correct?

I have emailed abba and waiting to see what they will do.

abba are normally pretty good so i am sure they will sort any problems out for you..

Try the standard fitting kit that comes with a new stand.
Both sockets fit my NC35.
You would only need a 12mm pin adapter to go into the spindle head.

NC30 requires a larger socket adapter and new larger 14mm spindle head pin.

These are mine, is there a short 14mm pin adapter available for the 30, rather than the new complete long one.

Yep, I had problems too. Eventually fixed it. Forgotten how, but it certainly wasn't obvious, and I may have reverted to one of the CB1000R fitments to make it work. Just couldn't figure kit 19.

arsey30 wrote:Try the standard fitting kit that comes with a new stand.
Both sockets fit my NC35.
You would only need a 12mm pin adapter to go into the spindle head.

NC30 requires a larger socket adapter and new larger 14mm spindle head pin.

Since the kit has two adapters it never occured to me to try the stand without one.
Cheers guys.

didnt want to create a new thread for this but does anyone know what kit is needed for the nc30? or alternatively if anyone has the bits for sale?
ive managed to lose the bits i had. thanks