can anyone help with a bit of info please? do other bike cans fit onto the 23? ive seen an old fireblade can going cheap and wondered if it would fit ok,cheers

Are they 3 bolt jobbies? or slipons?

oops sorry,i should have said its 3 bolt mate from the early blades

get an adapter to fit a slip on then mate

Graeme France sells them for not a lot..then any 2 inch can from anywhere and you are sorted!

ah cheers for that

or do what i did, fit any slip on can, cut the end flush, take the cap off, line upp the 3 holes from the pipe, drill, weld a nut on the underside of the can face, put it back on and re-rivet it and you've just made a slip one can fit the 3 bolt from your exhaust pipe :)

Si, as it's going to be a trackbike if you are not that arsed just cut the flange off the end of the system and as said any 2" cans a good un (or buy a reducer as also already said)
Steer clear of anything over 420mm in length as it won't create enough back pressure, the difference is really noticeable.

cheers,i did pass on the blade can as i thought it would be to big/long,so would possibly be not right.i think i will just cut it as you say mate thanks again for the replies