hellooo, and a little question if I may...............
Posted: Fri Aug 08, 2008 4:51 pm
Hello everyone.
there have been some changes since I was here last and I've had to re register, this new place looks good.
anyway, on to the point of this post.
I've just dusted of the NC30 with plans of getting it MOT'd, I've done a load of work to it over the winter including replacing the exhaust, rebuilding the calipers and so on but now one of the bleedin fork seals is leaking
I have a seal here which is 41x54x11, I've been searching the interweb but cant find out if that is the correct dimension for the nc30 or if its an old seal thats left over from a different bike, can anyone help please.
A virtual pint is on offer to the first to answer. :D
there have been some changes since I was here last and I've had to re register, this new place looks good.
anyway, on to the point of this post.
I've just dusted of the NC30 with plans of getting it MOT'd, I've done a load of work to it over the winter including replacing the exhaust, rebuilding the calipers and so on but now one of the bleedin fork seals is leaking
I have a seal here which is 41x54x11, I've been searching the interweb but cant find out if that is the correct dimension for the nc30 or if its an old seal thats left over from a different bike, can anyone help please.
A virtual pint is on offer to the first to answer. :D
, bit early for you to be drinking isn't it?