Basically selling parts from a 1WG 3EN1 on ebay,

had a few people enquire about the downpipes themselves, will they fit the 3EN2? i was under the impression they would as the engines are near identical. Any feedback on this issue would be most appreciated.

(also selling with them the end can and link pipe - all standard will this fit too?

* Sent via PM

Yes - the full system will fit both 3en1 and 3en2 and the headers will fit the 2TK or FZR400R SP. In fact you'll see they are stamped with a 2TK part no.
Note the mounting under the footpeg is M7