Hi all,
Can i fit an NC30 rev counter and temp guage to an NC35 loom?
It's to go on my race bike, and at the moment the steering damper is rubbing on the underside of the speedo, and i cant see a way of getting the 35 assembly apart
And getting a "sciatsu" (not sure of the spelling) rev and temp guage is far more pricy than an nc30 one.
Can i mod my existing loom to accept the 30 bits?
Cheers

skinnydog0_0 wrote: Can i fit an NC30 rev counter and temp guage to an NC35 loom?

Simple answer for the tacho is no. Temp guage will fit fine.

Cheers Cammo,
Had better start saving for an after market one
Or i might just get the hacksaw out

It can be done, just swap the RVF internals over to the VFR rev counter casing. Works a treat

Drunkn Munky wrote:It can be done, just swap the RVF internals over to the VFR rev counter casing. Works a treat

Yep, that's what I did.

I think NC29 CBR400 tacho internals are also compatible with the rvf loom.

Thanks guys, caught me just before the hacksaw came out
Best have a look for some second hand clocks
Cheers