Hello chaos,

I have searched high and low so far for a full NC24 gasket set and I cant find one anywhere. Is there a good place to get a set? I have tried Wemoto, David Silvers and Ebay to no avail.

Thanks

Neil

nope you can't get one anymore :/

What gasket(s) do you need.

you can modify an NC30 head-gasket.. clutch cover and genny cover and sump are readily available too.

I will be after the head, genny and clutch cover gaskets, and probably a couple more small ones for the radiator pipes, but those I could do with gel gasket.

Thanks for the heads up on the NC30 head gasket, will have to give that a go, is it fiddly to do?

Neil

Nope it's pretty much identical, you might have a metal ring you need to remove from the NC30 one, I can't quite recall but it's literally a 5 minute job to do.

I will be after the head, genny and clutch cover gaskets,

David Silvers do all of these.. Genny is about £5, Clutch Side about £11, Sump about £6

probably a couple more small ones for the radiator pipes, but those I could do with gel gasket.

Which radiator pipes?

They don't have gaskets.. all of the water and oil hoses are either just jubilee clamps or sealed with o-ring.. this includes the thermostat and the chrome water pipe that runs across the V...

Neosophist wrote:

probably a couple more small ones for the radiator pipes, but those I could do with gel gasket.

Which radiator pipes?

They don't have gaskets.. all of the water and oil hoses are either just jubilee clamps or sealed with o-ring.. this includes the thermostat and the chrome water pipe that runs across the V...

That's the one, the chrome water pipes in between the 'V', I got confused. O-rings, that saves a job I suppose.

Found most of them now, thank you. Just got to sort the NC30 head gasket now. Should be simple enough as they are common on ebay.

THANK YOU!

No problem.

That chrome water pipe is sealed with 2 rubber o-rings... do not damage this pipe there obsolete and new ones are impossible to find.. I had to make one when mine developed a leak.

Each end of the chrome pipe shoves into a right hand metal block thats sealed to the block with an odd shaped o-ring (non-standard part) but i re-used mine and it was fine.