Just wondered if anyone has cut down an end can before and would be willing to do mine

Might give it a go myself tomorrow not sure though.. how easy is it..

Easy mate, drill the rivets, cut too length, drill and rivet back together. Is it damaged then?

Not damaged, but think it would look nicer if it was shorter.. plus its running slightly rich and having a shorter pipe may sort it

Managed to do it ok.. took about 5 hours in total.. main problem was putting it all back together after as after clamping the can in a vice bent it slightly. Bike does run slightly better with a bit more growl, I can almost hear the exhaust over the induction noise if I turn my head back

Here are some before and after shots..

What do you think? Me likes..

Before....



After....

is tidy,,wot areya going to start chopping at next

nice and looks good!

Cheers, I have moved the shock res to under the seat.. bit neater..

Not sure what to do next now..

Maybe carbon fiber rear huger and an updated front fender in carbon

lights lights lights lights lights

yup that's true.. need to write a list

once you start a lits it never ends