can anyone tell me which way the rear sprocket fits fitted mine with the stamped side out it came without instructions so asumed the face with the sticker and size faces outward am i incorrect

davethetrucker wrote:can anyone tell me which way the rear sprocket fits fitted mine with the stamped side out it came without instructions so asumed the face with the sticker and size faces outward am i incorrect

You're bang on Dave

Writing and sticker face outwards.

Writing and sticker face outwards.[/quote]
thanks polisher, just changed chain as other one was an ebay purchased racelink chain and appeared to have a tight spot which gave problems getting tension spot on. after changing it to a new rk x ring i seem to have the same problem noticed slight wear on the outside edge of the sprocket teeth [ only done about 500mls] i am sure g/box sprocket is right way round so problem could be rear hub/bearing possibly.

so does the lip face in or out?

banoffee wrote:so does the lip face in or out?

thats what i was unsure of the flat side has the size and renthal sticker on it so assumed it was the outward side and the lip side inner if fitted wrong way would give alignment problems as i noticed slight wear on the outer side of the teeth , going to remove sprocket carrier as i think i may have stupidly fitted thrust washer on the wrong side which may be my problem i have both washers between hub nut and hub does the thinner one go behind the sprocket carrier

they offset towards the wheel, lip inside.

guess whose was on the wrong way round

now sorted, got to be good for another bhp or two at the back wheel

lip inward, assuming you havent got a 750 rear wheel?

thanks fellas it was on lip to inside all ok that way, was unsure so thought i would ask the bretheren . changed hub/bearings sorted thanks