Page 1 of 2
Ht Lead Diagram Please?
Posted: Sat Feb 27, 2010 3:31 pm
by Craigb
anyone got one for a nc29?
Thanks!
Craig
Re: Ht Lead Diagram Please?
Posted: Wed Mar 03, 2010 3:36 pm
by Craigb
Anyone??
Carn't seem to find anything.
I think the two closest to you as your sat on the bike (talking where they screw into the coils here) go into each end, then the other two cross over ?? Is that correct?
Got my new ht leads yday, gonna go down and put them on today/tomoz so would be handy to know tthat im right before hand lol!
Thanks, Craig
Re: Ht Lead Diagram Please?
Posted: Wed Mar 03, 2010 3:51 pm
by Davez29
Will this help?
http://www.cmsnl.com/honda-cbr400rrr-nc ... t/F28.html" onclick="window.open(this.href);return false;
Re: Ht Lead Diagram Please?
Posted: Wed Mar 03, 2010 5:23 pm
by cbr400rrn
Craig how much were the HT leads for 4 of them?
Durka durka where did you find that? It wont help me but i will bookmark it though for when i do need it

Re: Ht Lead Diagram Please?
Posted: Wed Mar 03, 2010 6:13 pm
by Craigb
Thanks for the diagram mate but know you've confused the hell outta me.
Iv set it up how i thought, and iv got it running, seems fine.... however now iv seen this diagram it's showing them in a differant sequence to how i have them!!?? :S lmao
Looking at that diagram, i have 9 and 11 the oppasite way around....
surly it wouldntd start if they were wrong?
And i picked a set up with the coils attached from ebay, £20 plus £6 postage.
Re: Ht Lead Diagram Please?
Posted: Wed Mar 03, 2010 10:50 pm
by jac_is_smiling
If it runs cleanly on all 4 i wouldnt worry too much about it.
RHS coil as you sit on bike supplies cylinders 2&3 with spark, what HT lead connects to what side of the output of the coil doesnt matter, as long as both are connected to RHS coil output side
LHS coil obv supplies 1&4 with spark.
Not sure how it would run with 9 and 11 oposite way round.
Re: Ht Lead Diagram Please?
Posted: Thu Mar 04, 2010 2:10 pm
by Davez29
cbr400rrn wrote:where did you find that? It wont help me but i will bookmark it though for when i do need it

I thought most peeps here knew about CMSNL? anyhow, just back track on the address to get the full fishe for any model you may need, if you have not already done so.
Craig, I have my leads set out as the diagram shows, maybe you still got the firing order right some how? Im not techie enough to understand how it works so im just as confused.
Re: Ht Lead Diagram Please?
Posted: Thu Mar 04, 2010 3:00 pm
by Craigb
lol! hmmm, i might swap them around anyway, and if it still works leave them as the diagram is. Just a pain in the ass to get back at them lol.
Re: Ht Lead Diagram Please?
Posted: Sat Mar 06, 2010 6:47 pm
by yeurman
this might help:
http://diddley.smugmug.com/Motorcycles/ ... PQWdW-A-LB" onclick="window.open(this.href);return false;
Col
Re: Ht Lead Diagram Please?
Posted: Sat Mar 06, 2010 7:46 pm
by Craigb
i cnt work it out from that but thnks lol