Page 1 of 1
Float Height Adjustment
Posted: Mon Jan 11, 2010 10:01 pm
by madmike
Moving on from my previous thread.... on a CBR400RR (NC29)
Do you have to source the new float needles and other parts if the float height needs adjusting or... Can they just be adjusted by bending?
Re: Float Height Adjustment
Posted: Thu Jan 14, 2010 2:25 pm
by madmike
bump
Re: Float Height Adjustment
Posted: Thu Jan 14, 2010 2:44 pm
by CMSMJ1
Bend them dude...carefully
Re: Float Height Adjustment
Posted: Thu Jan 14, 2010 6:36 pm
by madmike
Thank you!
Re: Float Height Adjustment
Posted: Thu Jan 14, 2010 7:03 pm
by Davez29
The floats are all one piece plastic on my bike. Would the plastic tabs on the floats stop where you put them? I would be wary of trying to bend them, perhaps source a spare first just in case. Have you checked the float height adjustment and if so how far is it out?
Re: Float Height Adjustment
Posted: Sat Jan 30, 2010 6:54 pm
by atheos_mb
According to haynes manual the nc29s need replacing where the nc23s can take a bend