Hello chaps.

Got a project NC30 with Tyga rearsets fitted. There is no rear brake light switch assembly fitted to it, is there something missing or will I need a banjo pressure switch?
If it does need a pressure switch does anyone know the thread size so I can order one whilst i'm at work.

Ta.

Garry.

RHG wrote:will I need a banjo pressure switch?

Hi Garry, the answer is in the question. I don't know of any aftermarket rearsets that incorporates the switch.

I pretty much knew what the answer would be but just thought i'd check

Thread size anyone?

Done a quick search and discovered they are M10 x 1.25

Cheers.

Yep, 10X1.25 is the one you need.

viper_biker wrote:

RHG wrote:will I need a banjo pressure switch?

Hi Garry, the answer is in the question. I don't know of any aftermarket rearsets that incorporates the switch.

BEET rearsets incorporate the switch Viper you now know of one that does

Gavin jap4 wrote:BEET rearsets incorporate the switch Viper you now know of one that does

<<<--------------------- EDUCATED

Gavin jap4 wrote:

viper_biker wrote:

RHG wrote:will I need a banjo pressure switch?

Hi Garry, the answer is in the question. I don't know of any aftermarket rearsets that incorporates the switch.

BEET rearsets incorporate the switch Viper you now know of one that does

Sent you an email recently regarding RC211V u/tray and an exhaust. Did you receive it?

Here is some more EDUCATION VB, my Phase rear set incorporate it to and you stood looking at them

WR rearsets also use the standard brake switch...