Thinking to make following exhaust modification.

hmmm the angle od the end can looks wrong to me pointing up too much

it looks like the wrong can has just been stuffed on the end...whats with the dodgy angle where it joins the headers???

i dont think that even justifys a response. it is utterly gastly. the can is bodged on and the calipers look totally out of place.

Shouldnt take much to put a small bend pipe on so the pipe runs parallel to the tail section

That's gotta be a Japanese photo, they have some strange ideas about what looks good on a bike, god knows what they're on

as miki mentioned. "high level" cans are supposed to run parallel to the bottom of the tail unit. not sticking up in the air to fill with rain!

That is a sweet paint job on the fairings. Not too sure about the angle of the can, but many race bikes are like that so go for it!

I think there is plenty of examples bike with same angle of the can. For example, Rick Oliver vfr have same can and angel.
Is the angle of the can influence to performance of the bike?



I also saw ZX-6R with same angle. Looks quite nice.

High level cans are about increasing ground clearance.