This bar has a bolt that goes into it through the clip on clamp, think this is the only model they ever used these bars on, I currently have 1 fitted but appears to be slightly bent as turning left the bar almost touches the tank but turning right is about an inch away. I personally hadn't noticed but a m8 of mine had a go on me bike n says it felt off balance to him n disdcovered the slightly bent handlebar.

so if you've got a spare n it's straight pm me with a price,

Cheers Q.

FZ600's had the same bars

Very late reply, but do you still have a locating pin/dowel? (from the bar block to the top yoke) - steel rolled pin into alloy
Mine has an oval hole from wear & tear - but should actually make the bars align (reasonably) evenly

dancon3105 wrote:Very late reply, but do you still have a locating pin/dowel? (from the bar block to the top yoke) - steel rolled pin into alloy
Mine has an oval hole from wear & tear - but should actually make the bars align (reasonably) evenly

CHEERS FOR THAT...

Pin removed and realigned.

Q.