anyone brought one for the gsxr
ive got one and its makin a right noise ,and it looks like its hitting the inside of the chain
think the flats on the teeth are to big , the old one sprocket teeth are like ^ ,this talon one as a 4mm flat?

just wondered if anyone else had this problem ,thanks

Hi Jay,
I run Talon on the Bandit and they are a bit wider. They are like this to give a bit more strength being alloy, but ive had no probs with mine. Is the chain good, tensioned correctly and the wheel in line as they are a bit more sensitve to set up.

Variablevalves suck wrote:Hi Jay,
I run Talon on the Bandit and they are a bit wider. They are like this to give a bit more strength being alloy, but ive had no probs with mine. Is the chain good, tensioned correctly and the wheel in line as they are a bit more sensitve to set up.

yep everthing new , and i also put some shims in the rear sprocket as the chain was snagging on the right side of the chain , still same ,thinking of going back to the dull grey sprocket .alignment is good too

try to check if you were sent correct chain for bike (gk73a is 525 chain imagine same for 76 model)