Thermal tool linky please bill :-)

Last autumn Boris; It is only a cheapy but adequate for whats required; like this one
http://www.ebay.co.uk/itm/Digital-Infra ... 20e5115c6e

Someone may get the linked one for pennies.

EDITED FOR ADDITIONS:
Loads on here;
http://www.ebay.co.uk/sch/i.html?_odkw= ... n&_sacat=0

They are that cheap; I might buy another and be like "Two gun Tex."

Me likey bid slapped on cheers bill

You will have clocked the 2x sets of carbs from the same seller up at a good start price;

I cannot recall if the Genesis has that carb type though .( Don't they have the metal tops ?)

Do not have experience of Exup carbs on a none exup engine; anyone contribute here ?

Theoretically; with jet swaps, there should be no excessive problems.
The dia. are the same.

Edit; coz I missed the l off metal ( which caused confusion)

will have a look bill cheers and meta tops ?? not sure what they are please educate me

Edited for disgraceful spelling; was in a hurry !
Shocking behaviour......... simply not acceptable.
Hides in brush cupboard with head held low in shame.

and there was me thinking you were about to enlighten me on yet another short fall of mine lol

yes mine have the metal tops covering the diaphragm .

cant find them carbs mate

Bill do those guns have a hot enough range for use on headers?
I've been after an excuse to buy one for ages and could have used one at a trackday on Monday.
Thanks

Yes they do; I use mine on the bend at the very top which is the hottest part of the pipe.
It gives the most consistent reading and an easy to re-read target.

Just gone out and done a little test; (coz I was interested in the question too )

Gun is rated to 380 c.

At Idle and warmed up ; 1100rpm = headers 270 c and remained stable at this temp.

Run at constant 6000rpm for 3 minutes = headers rose from 270 c to 450 c on the gun.

At 450-454 c the gun screen flicks back to 450 c (like a page refresh )

It is unknown how hot the headers got above this.

The guns will be rated accurate to 380 c but must go higher .

I can not recall seeing over 295c when I have been on with it previously doing mixture screws.

Nice when you learn yourself something .

Ah but will it give consistent temp reading when I set fire to this bloody bike