Any updates on this?

First of all I am very sorry for the delay.
The good news is that all of the moulds have been made for the Honda NC30 and NC35, at last.
I am expecting to have a batch of parts (NC30) and samples (NC35) by Friday 23rd Nov.
If all of the samples are good then production is usually 3 weeks. However, I have to send the NC35 float bowl and airbox seal samples to the UK (I am in Thailand) to confirm that they are a good fit.
I am also doing kits for Yamahas and Ducatis, but the Hondas have priority at the moment.
cheers
Blair

will you be replicating the float vlaves as well?

The kits are seals and o-rings only.
Here are some more details.
We have set the price for the NC30 kits (for 4 carbs) at 1000THB (Thai Baht) including free registered airmail.
We will not be selling kits for one carburettor or separate parts.
All parts are made from Viton 70A.
cheers
Blair

Thats £20 a set right?

Yes, that is about 20 pounds for a kit. A kit is for 4 carburettors.
Just so you know I am not blowing smoke, here is a pic of the float bowl seals for the NC30. They arrived today and I am very satisfied with the quality. They have the same oval section as the Honda part. Just waiting now for the
o-rings.

sweet! i'll like to get a set when they're ready!

I would be in for a couple of sets - any updates

Thanks for your interest and patience.
All going well I should have them in a week or two and for the NC35 about 4 weeks.
I will PM those of you who have expressed interest as soon as they are available.
If you are in the UK you will be able to get them from Rick Oliver at the same price.
Blair

I'd be interested in a set as well, thanks!