I don't use a fan at all and have previously ziptied the rads on when I ws in a hurry to test stuff...

come on man...lets have your moto come and play

Whereabouts can I ziptie it to? I don't mind doing this as I need to give it a good thrashing soon as its been months since i last took it for a proper ride.

it is the bolt on top left isn't it? The rad slides over a pin on the right hand side and is held fomr that corner solidly. You would then have the lower left on holding it in fromt hat side and you just need to pull the top left corner back to the bike - the clutch and speedo gubbins should sort that??

Or I am wrong..lol

You ar enot too far away are you and as this is a bike workshop there might be some magic skills on hand to extract your snapped nut..

Yeh should be able to sort something out then, will see how it goes. When you say a bolt it slides onto is this part of the frame? The side it has gone is the upper left mounting when sitting on the bike so the opposite end to the filler cap. Ah well I shall give it a go.

anyone from surrey going to be riding up?? might fancy it if anyone is..

my top rad is zip tied, its solid as a rock

i'll try and get down, need to drop my bike off for some work doing...

Simon_Ed wrote:i'll try and get down, need to drop my bike off for some work doing...

Some more work? lol - what is left?

Hi All,

Everyone welcome to pop down tomorrow, I should be around from 9am onwards and will be here till the last one leaves. See you tomorrow

Cheers Mike @ BMC Racing.

Ok i'm a bit of a spanner, I thought we were on about sunday have only just this minute realised that it is tommorow it was meant. Means I need to find a way to bleed the brakes tonight, bugger. Will find a way to get there.