Fantastic job the finish looks great the only color ive done with cans was matt black.
Im gonna strip the tank fully so i can start fresh.
Any specific types of paint,sandpaper etc used

nitomors, paint it on thick and leave for a good 1/2 hr, in winter it doesn't dry as quick (in summer it can dry and its a pain in the as*) and then i used a paint scraper to get off, just 1.5" flat, takes a while and you need to follow the contours especially round where your thighs go. recommend gloves and be careful as the factories use filler for small discrepancies.

did the tank this week came to put on wings and decided after looking at a few pics to follow the front ridge line down making the top wing flat i think but an impression of taking off (do i think about this too much?) its also a slightly smaller set of as well.

GO KIWI!!
stimpy

BEEN A WHILE BUT GOT MY LADY BACK TODAY AT HOME WHEELS ON ALMOST FINISHED FRAME.

when shes fully operational should look like this.

missinNZ wrote:

Rusty nuts disfigure all picture...

finished of decals on other side today, only left with spraying in the triangle of black on lower mids, get nose decal from brooky and then lacquer the lot (and the laborious job of putting back together).

doing my bit for the site, had brooky from here make this up for me

Nice.
:)