Page 2 of 2

Re: gk71f

Posted: Sat Dec 19, 2015 8:01 pm
by bartman400
mike151 wrote:Hi, interesting to hear about middle cylinders needing bigger jets, I think someone's cocked up & put the bigger ones in the right hand pair on these.gonna get my main set off again & check them ,cos bikes still not quite right, don't think I cleaned needle jets properly,ie didn't take them out.
hi mike! you should be able to see through the pilot jets,from front to rear, [just]..tiny hole, make sure the main body of the carbs is clear? cheers!!

Re: gk71f

Posted: Tue Nov 01, 2016 5:22 pm
by mike151
Was at an autojumlbe a few weeks ago & there were some Gsx 550 carbs which looked exactly the same as mine but had mikuni written on them. I roughly measures them & found them to be the same. Wondering if jets are available for these mikuni carbs & whether they'd work on a gk71