Page 2 of 2
Re: R6 Exup End Can works with 3EN1 Stainless System
Posted: Mon Jul 20, 2015 2:06 pm
by willandrip
For future reference;
http://www.ebay.co.uk/itm/Yamaha-R6-YZF ... 2354431875
I had no idea these were so cheap !
It really does like a good solution to a rusted out std. Exup system in conjunction with the S.S. headers.
Re: R6 Exup End Can works with 3EN1 Stainless System
Posted: Mon Jul 20, 2015 3:50 pm
by Wraith
Re: R6 Exup End Can works with 3EN1 Stainless System
Posted: Mon Jul 20, 2015 8:12 pm
by Clanky
I agree that a shorter link pipe would look better but I didn't have time to muck about with the fitting (my wife expects me to finish decorating the hallway before the bike
).
The angle of the hanging bracket on the r6 does effect how the end can sits and brings it very close to the swing arm. I got custom 30 degree swept link pipe but a 25 might be better. The link pipe is 1.5 mm thick and the outer diameters were 44mm and 54mm (but double check before you order)
I'll take a better photo from a distance to clearly show how it looks and the exhaust angle.
Re: R6 Exup End Can works with 3EN1 Stainless System
Posted: Tue Jul 21, 2015 2:51 am
by Wraith
Can you let me know the Length of the ExUp Control Pipe plz
I'm sure I can find a few Smashed up End Can's to cut the ExUp off
