FULL BEAM, INDICATORS AND REAR LIGHT WORKS WOULD A DIFFRENT FUSE BE RUNNING THESE

I don't get easily offended by capslock, so I'll reply

First thing's first, have you pulled a globe out and checked the wattage that is written on it? That is quite possibly the route of your problem and will only take a minute to check. Then we can all offer more advise.

the same thing happened to me......the dipped or main beam was the only one that was not working!!!
remove the block connector that comes from the switchgear and on the other connector bridge the connections until hopefully the dipped beam comes on.this way you will know for sure its the switchgear.

in my case it was the switchgear.



william

i fixed it took left switch gear apart, WD40 lot of. Now works fine

Thanks for all you help