Page 2 of 2

Re: NC30 Rear Wheel Split Pin

Posted: Thu Apr 04, 2013 9:45 pm
by thunderace
Worther wrote:Hi Folks,
I've had a search for this question, bit can't find the answer...how do I get replacement 'Split Pin' for the rear wheel nut? On my bike it had been on for a while and one 'leg' broke off upon re-assembly.
Is this a Honda only item?
I've looked on Rick Oliver's website (haven't phoned though) and couldn't see it.

Any help would be appreciated.

Thanks,
Just a standard Cotter Pin. Length doesn't matter as you can trim them down or wrap them around.

FWIW, I buy assorted packs of 500 S/Steel ones for about £4 which cover pretty much every application where one is required.

Re: NC30 Rear Wheel Split Pin

Posted: Fri Apr 05, 2013 3:48 am
by Neosophist
Marcos wrote:I take it the R clip has to be 2.5mm, how long?
Ill measure it for you if you like, I got it from a bike shop and it said for VFR/RVF on the packet.

Image

You can see it here.

Re: NC30 Rear Wheel Split Pin

Posted: Fri Apr 05, 2013 8:42 am
by thunderace
You missed a bit Neo :P

Re: NC30 Rear Wheel Split Pin

Posted: Sun Apr 14, 2013 4:58 pm
by bikemonkey
Neosophist wrote:
Marcos wrote:I take it the R clip has to be 2.5mm, how long?
Ill measure it for you if you like, I got it from a bike shop and it said for VFR/RVF on the packet.

Image

You can see it here.

Did you ever get the measurement for this Neo?

I'd like to get one as I'm always taking my back wheel off for cleaning.

Re: NC30 Rear Wheel Split Pin

Posted: Sun Apr 14, 2013 9:55 pm
by iDemonix
It's just a split pin, get them from anywhere!

Halfords do a multi-pack of them if you're in a rush with about 10 different sizes.

Re: NC30 Rear Wheel Split Pin

Posted: Sun Apr 14, 2013 10:00 pm
by bikemonkey
I was on about the fancy stainless R-clip ;)

Re: NC30 Rear Wheel Split Pin

Posted: Tue Apr 16, 2013 11:45 pm
by Morespeedvicar
the r-pin on mine is 52mm long over all, i'm liking the idea of a stainless one tho.....

Re: NC30 Rear Wheel Split Pin

Posted: Wed Apr 17, 2013 7:17 am
by Neosophist
http://www.amazon.co.jp/gp/product/B001 ... 9AHQBEKRBD

This is the one I have, its made my aftermarket maker called POSH.

I will measure it when I get chance