• eBay nc30/35 fuel tap mod???

Posted: **Sun Dec 16, 2012 10:00 am**

pip wrote:Reading this, I have fixed (bodged) several 'permanently on' Honda vavuum taps over the years.

Inside the end cap is a small steel plate pressed in that has a tiny hole in the middle, behind which is a thin rubber baffle - I believe this rubber swells/ deforms with age. Sometimes flipping it over works, if not I have just removed it & all works perfectly again

When this rubber baffle deforms it prevents atmospheric air back into the chamber when the engine is turned off & thus closing the tap.

Or you could buy the repair kit!

Pip

Cheers for the info, I'm goin to try and strip it down today.

Luke

Posted: **Sat Dec 22, 2012 2:11 pm**

Does anyone have a link to schematics for rebuilding the tap? I've got the parts from RO but have no idea how they go back together and my Haynes manual doesn't seem to have much about it.

Posted: **Sat Dec 22, 2012 3:34 pm**

Look on lings motorcycle parts, all the fiches are there, a great resource for getting an idea on prices & component breakdown/ assembly.

Pip

Posted: **Mon Dec 24, 2012 12:47 am**

juggernaut wrote:Does anyone have a link to schematics for rebuilding the tap? I've got the parts from RO but have no idea how they go back together and my Haynes manual doesn't seem to have much about it.

I found Mike's site really helpful, this is for 'hrc-ing' the tap but it also shows how it normally goes together: http://www.akhara.com/nc30/fueltapmod/index.html

Posted: **Tue Dec 25, 2012 11:35 pm**

Thanks all done now miles site was very helpful thanks cammo.

eBay nc30/35 fuel tap mod???

Re: eBay nc30/35 fuel tap mod???

Re: eBay nc30/35 fuel tap mod???

Re: eBay nc30/35 fuel tap mod???

Re: eBay nc30/35 fuel tap mod???

Re: eBay nc30/35 fuel tap mod???