Page 2 of 2
Re: 660 stroker rods
Posted: Mon Jun 11, 2012 12:40 pm
by Alex.
nynoah wrote:The other thing I was hoping to figure out was if the profile of the fazer flywheel was the same as the FZR 3HE. Because it looks like the same pickup points as the YZF600r.
That's a very good question, especially as I have just taken delivery of a fazer crank and rods!
I think that EC0 has all three cranks in his possession, can you get the measuring stick out Boris?!?
Alex.
Re: 660 stroker rods
Posted: Mon Jun 11, 2012 1:40 pm
by Evilchicken0
4JH
FZS
3HE
I think the 3HE is narrower although the picture makes it look the same - I'll be at college tomorrow evening and give it a proper measure then. I'll try and get the 4JH stator off but I think there's a difference it's in the FZR Archives tread.
How many sets of rods do you need ? have a look and find out the cost / weight to ship and I can maybe calc the optimum no of sets ...

Re: 660 stroker rods
Posted: Mon Jun 11, 2012 1:47 pm
by Evilchicken0
And another thing
The Fazer's red line is 12.5k rpm on the clocks
The 4JH is 13k
The 3HE is 11.5k
The rev ceiling isn't down to the Fazer rods