Page 2 of 3

Re: 3en1 4/6 project

Posted: Wed Feb 01, 2012 1:26 pm
by thunderace
Evilchicken0 wrote:No honda is honda ..... you only use a capital or uppercase for propper nouns, like Yamaha. There's nothing propper about hondas in an FZR forum.

:grin: :peace:

I agree there's nothing proper about Hondas, but Honda should have a capital letter as it's a brand name and Honda themselves use a capital H :P

Re: 3en1 4/6 project

Posted: Wed Feb 01, 2012 6:12 pm
by Hogdigerdy Dog
thunderace wrote:
Evilchicken0 wrote:No honda is honda ..... you only use a capital or uppercase for propper nouns, like Yamaha. There's nothing propper about hondas in an FZR forum.

:grin: :peace:

I agree there's nothing proper about Hondas, but Honda should have a capital letter as it's a brand name and Honda themselves use a capital H :P

only because they've got ideas above their station ;)

Re: 3en1 4/6 project

Posted: Sat Feb 18, 2012 9:28 pm
by Bikemike
Evilchicken0 wrote: There's nothing propper about hondas in an FZR forum.

:grin: :peace:
On the Kr-1s forum if you type in "Honda" the swear filter turns it to "H****" :twisted:

Re: 3en1 4/6 project

Posted: Sun Feb 19, 2012 1:04 pm
by Evilchicken0
Every time I type "h****" it comes out "h****" ... ;)

Today I sold my honda 400 Four

Re: 3en1 4/6 project

Posted: Sun Feb 19, 2012 4:46 pm
by Hogdigerdy Dog
Evilchicken0 wrote:Today I sold my honda 400 Four
hope you got what you wanted that is a sweet 4/four

Re: 3en1 4/6 project

Posted: Sun Feb 19, 2012 5:47 pm
by Evilchicken0
Not bad actually - £1875

Re: 3en1 4/6 project

Posted: Sun Feb 19, 2012 8:25 pm
by thunderace
Evilchicken0 wrote:Not bad actually - £1875

Now you can replace it with a proper bike :mrgreen:

Re: 3en1 4/6 project

Posted: Mon Feb 20, 2012 10:53 pm
by Evilchicken0
I've got the 3TJ and the Bimota

Re: 3en1 4/6 project

Posted: Tue Feb 21, 2012 4:41 pm
by Hogdigerdy Dog
Evilchicken0 wrote:Not bad actually - £1875
that's a good result then :grin:

Re: 3en1 4/6 project

Posted: Tue Feb 21, 2012 10:46 pm
by Evilchicken0
Yup. I had to replace the head gasket which was a bit of a mission but it was a relatively simple engine so a good one to cut my teeth on.
I've been going to college in Lambeth doing IMI 2 in Bike Mechanics ... maybe a twin cam next then.