Rick, thought they were same as RVF! Doh! Its RVF one I need, dont like tall 1st gear on NC30 box, no good for getting off line.

It`s the same size pinion, Aly (29T) but the RVF version has stronger, square engagement dogs on one side.

Rick

Don't think I have the balls to take apart a gearbox just yet

iDemonix wrote:Don't think I have the balls to take apart a gearbox just yet

Go on! It's alot easier than you think.
Personally, the whole removing procedure would be more pain then rebuilding the gearbox

Would this help my NC30 get into neutral easier?

No - that neutral selection problem is almost certainly being caused either by a clutch fault or by a non standard footrest kit with the wrong leverage ratio on the gear linkage...

Rick

RickOliver wrote:No - that neutral selection problem is almost certainly being caused either by a clutch fault or by a non standard footrest kit with the wrong leverage ratio on the gear linkage...Rick

i wondered why my biek Stuggled to get Neutral everynow and again, i have BN TYGA rear sets and it struggles, sometimes have to give it a bit of throttle to get it in N. thanks

What's the word on these?

Slow progress as all these projects tend to be...

ETA on the first two prototypes is around another 3 weeks but they are both spoken for. If they work OK I`ll get another batch (probably 5) under way ASAP.

Rick

RickOliver wrote:Slow progress as all these projects tend to be...

ETA on the first two prototypes is around another 3 weeks but they are both spoken for. If they work OK I`ll get another batch (probably 5) under way ASAP.

Rick

Hey Rick

Just out of interest, are the 2 prototypes spoken for by people who replied to this thread or elsewhere?

Cheers
Luke