Yeah it hits the swingarm!

You'll need to be creative with spacers etc.

What size tyre you have fitted to it?

It can be done though depending on rubber, as I had it spinning freely when I was experimenting.

Time / money / enthusiasm / other bikes meant I never finished it and it's currently running on standard rear wheel

it's far too wide to run on an nc24 swingarm,
even spaced out to the end of the studs(which is a mile off centre!),
it still hits! the nc30/35's must have a differant
curved radius in the arm there is NO WAY this rim will fit an nc24 arm.
i am getting a complete bros rear end in a few days so maybe a hybrid of bros swing
arm coupled with the '24 hub/axle may work i'll keep you posted on my findings!!