Page 2 of 2

Re: NC35 track bike dieing at end of session

Posted: Thu Apr 29, 2010 9:13 pm
by [STU]
ok, many thanks again guys for the input.
Seems like i will have to have a look at the carbs. So ill have to do a bit of research here to find out what im looking for.
No i just need to find the tie to do it between now and late May when i have my next track day lined up.

Any other Sydney based Aussies heading to Eastern Creek in late May?

Re: NC35 track bike dieing at end of session

Posted: Fri Apr 30, 2010 2:03 am
by Cammo
Stu, the culprit might be something as simple as the pilot screws being incorrectly adjusted (they should be set at 1 + 5/8 turns out for your setup).

Using HRC emulsion tubes might also help your symptoms, but check the PS setting first.

Re: NC35 track bike dieing at end of session

Posted: Fri Apr 30, 2010 2:51 am
by [STU]
DataRacer wrote:Stu, the culprit might be something as simple as the pilot screws being incorrectly adjusted (they should be set at 1 + 5/8 turns out for your setup).

Using HRC emulsion tubes might also help your symptoms, but check the PS setting first.
Thanks mate, ill give it a shot as soon as i can.
Appreciate the input.
Stu