By the looks of it the exhaust is not the standard one, it has got two loops for the exhaust springs to hold the end can on, could be wrong! Either way the pipe looks strange.

right then..your pictures show a long pipe with spring tabs on it. These are not on a standard NC30 system..

Yours had had a pipe welded to it it would seem?

get a grinder out and chop it off wherever you want!

Hey Hey i seem to of got somthing right for once! lol

i thought it looked pretty standard it hasnt got any bodged welds this side of collars!! bugger things are never easy are they!! right next question is where do i get a link adaptor to fit this dodgy pipe?? or should i try and get an original link pipe to fit my adaptor and end can?? what a bloody nightmare!! i wish i listened when my dad was teaching me mechanics!!!!!!!!!!!!!

ebay.co.uk HONDA VFR400 NC30 1989-93 EXHAUST TO SILENCER LINK PIPE (#310160012511)

would this help me?

doubt it, you will probably get the same link pipe you already have, if you read the listing it says the pic is for refrence only. just a point have you tried to fit the exhaust with out the link pipe?

Infact that would prob work looking at the pic's, just because the pipe seems to end at the same point it would if you cut a standard system and used the link pipe.

you reckon the end can would fir straight onto the link pipe?? i must admit i didnt try it!! i reckon you might be right!!! DOH!!

you might need a 60mm inlet rather than the standard 50mm..

get it tried..lol

hi, i am still struggling with this exhaust, it wont fit straight onto the pipe for two reasons. the link pipes diameter is slightly two large the end can to slip over and vise versa, and secondly it appears if it did fit the exhaust comes out at the wrong angle and fouls the the bracket and rear footpeg!!. Its becoming a nightmare, if anybody has any ideas i might have to take it to bike garage and pay through the nose!! Please help.

Many Thanks
Kris