NC30 dog bone linkage length

ozracer · Post by **ozracer** » Thu Nov 12, 2009 1:16 am

Hi all, I'm a new NC30 owner and need a little info please. I have just bought an NC30 race bike with a 17" RVF rear wheel but am unsure if it has an NC30 or NC35 dog bone linkage. Could someone please tell me the length of the standard NC30 dog bone linkage so I can compare it to the one on the bike? Thanks in advance for your time and effort.

Post by **Cammo** » Thu Nov 12, 2009 2:15 am

Welcome to the site mate, there's a massive amount of vfr400 knowledge on here.

I'll measure my nc30 one up when I get home later. It's an easy job to shorten (redrill) the vfr one to raise the rear if that's what you have.

Post by **viper_biker** » Thu Nov 12, 2009 3:06 am

Or you can buy my RVF one and not need to weld or drill anything.

Welcome to the forum.

Post by **RickOliver** » Thu Nov 12, 2009 8:57 am

Centre to centre of the front & rear bolts -

Stock VFR - 113mm
Stock RVF - 109mm
Modded Jackup link - 105mm (usually)

Rick

Post by **Cammo** » Thu Nov 12, 2009 9:08 am

Well there you go, had forgotten all about it....

ozracer · Post by **ozracer** » Thu Nov 12, 2009 10:47 am

Thanks for the info guys. I'll measure mine and see what I've got.

NC30 dog bone linkage length

NC30 dog bone linkage length

Re: NC30 dog bone linkage length

Re: NC30 dog bone linkage length

Re: NC30 dog bone linkage length

Re: NC30 dog bone linkage length

Re: NC30 dog bone linkage length