RVF Electrics 70% not working
Forum rules
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
- billnit
- Site Supporter
- Posts: 91
- Joined: Wed Apr 30, 2008 7:13 pm
- Bike owned: Not any more...
- Location: St Helens
- Contact:
RVF Electrics 70% not working
Guys
For some reason some of the electrics on the bike has decided to pack in.
Starter and high beam relay work (clicking and light on the dash working) but everything else - indicators, horn, clock lights don't.
At a loss as to what it could be - wiring is connected from each handlebar switchgear as start and hi beam works. Ignition is fine too, as starts no problems?
Any ideas before i start pulling things apart....
Thanks...
For some reason some of the electrics on the bike has decided to pack in.
Starter and high beam relay work (clicking and light on the dash working) but everything else - indicators, horn, clock lights don't.
At a loss as to what it could be - wiring is connected from each handlebar switchgear as start and hi beam works. Ignition is fine too, as starts no problems?
Any ideas before i start pulling things apart....
Thanks...
1996 Rothmans Rep RVF400 - 1997 Gilera Stalker 50 (soon to be "Malboro'd") - 2007 Honda Civic (manufacturer loyalty!!) - Audi A4 Avant S-line 2.0TDI - 1969 MGB GT
- Cammo
- Site Supporter
- Posts: 4505
- Joined: Thu May 01, 2008 12:35 am
- Bike owned: NC30
- Location: Melbourne, Australia
Re: RVF Electrics 70% not working
Best to take a look at a wiring diagram.
Most functions need an earth and positive to work, see if there is a common earth between the stuff that is working and the stuff that isn't, etc.
Check all earths (can't remember where they are at the front).
Horn not working would indicate no positive source getting to it, since it's already earthed (mounted). And so on.
Most functions need an earth and positive to work, see if there is a common earth between the stuff that is working and the stuff that isn't, etc.
Check all earths (can't remember where they are at the front).
Horn not working would indicate no positive source getting to it, since it's already earthed (mounted). And so on.
"It's just a ride" Bill Hicks