race can repair

Post by **Dgeoff33** » Wed Jun 10, 2009 10:58 am

I have an Ethos can with a rotten perforation tube, anybody where I can get it fixed?

Post by **Sligeach** » Wed Jun 10, 2009 11:09 am

http://www.aa16.co.uk/" onclick="window.open(this.href);return false;
perhaps? Their site used to be good, it seems they are underdevelopment now for a couple of months

Post by **viper_biker** » Wed Jun 10, 2009 11:47 am

Also try PJ Engineering, they made me a set of cans before from scratch. The weren't just a regular set either as the sizes were bespoke to the system. I'd dare say they would knock you one up if you had the inner diametre and length.

Post by **Spike16** » Wed Jun 10, 2009 4:49 pm

anr performance do exhaust parts, cant say for my self but smev's 'Arrow' can is made from their bits I think and its looks very good (if i could sell my scorpion carbon for enough to build one of their I would)

O my seat unit is from them and its very good quality also if that makes any difference

Post by **mrdidlydingo** » Wed Jun 10, 2009 7:41 pm

I use a guy in louth if thats any good ?

Good prices about 50 - 70 to re sleeve and re pack !

Post by **rcv4** » Wed Jun 10, 2009 11:50 pm

hi,i can supply exhaust parts or repair,if you have a problem.....i have been a exhaust fabricator for 15 years.

Post by **superlite** » Thu Jun 11, 2009 11:11 am

I've repaired a few Jap import exhausts in my time and the majority of them have knackered internals. Just get some 50 mm perforated pipe from any exhaust place and spot weld a couple of spots on to keep it where it should be. Most import exhausts are about 30% straight pipe and 70% perforated. Add packing and you're done for not much cash.

Post by **Sligeach** » Fri Jun 12, 2009 12:26 am

rcv4 wrote:hi,i can supply exhaust parts or repair,if you have a problem.....i have been a exhaust fabricator for 15 years.

in case you have missed out geoff this lad has a post in the exhuast sticky section, check out the lads handywork, unreal stuff

Post by **Dgeoff33** » Fri Jun 12, 2009 5:13 am

Thanks for the replies.

Declan, spoke to him yesterday, he's going to be doing it (along with some other stuff)

Post by **royster81** » Fri Jun 12, 2009 7:45 am

rcv4 wrote:hi,i can supply exhaust parts or repair,if you have a problem.....i have been a exhaust fabricator for 15 years.

oh really !!!

( i can see you getting bombarbed with email now ,"can you make me this system")

good luck geoff i hope you get something sorted.

race can repair

race can repair

Re: race can repair

Re: race can repair

Re: race can repair

Re: race can repair

Re: race can repair

Re: race can repair

Re: race can repair

Re: race can repair

Re: race can repair