Wanted Signal Generator & Coil

[jamierooney]

Hey there - thanks for the pic. See the cable coming off the inside of the plate - well on the white plastic connector that the 2 wires go into, put the meter pins/sensors one into each at the same time - and set your meter to read ohms (Ω) - there are normally setting like 10Ω or 100Ω or even 1Ω - any of these should do.
just let me know the amount it reads out.

thanks again.

[Gavsta]

Hi,

When set to X10 it reads 8 on the meter.

I dunno if that helps at all?

Gavin.

[jamierooney]

Hi Gavin.
The resistance of yours is actually reading less than my own, so I dont think it would serve me any advantage to buy it from you dude.

Did you have any starting issues with it before it was broken for parts? I know you had it for racing , did you leave the electric start on it when it was a race bike?

Thanks
Jamie

[Gavsta]

Hi,

No there were no starting or running issues at all.

Gavin.