Exhaust question

Sean · Post by **Sean** » Wed Feb 04, 2009 7:15 pm

Hi there
I need to replace the downpipes on a 1wg. Could anyone tell me if the downpipes from a 3tj are the same.
Many thanks
Sean

Post by **Taggyd** » Wed Feb 04, 2009 9:02 pm

dont think tj ones fit, but theres a set of 3en1 on ebay at the min!

Sean · Post by **Sean** » Wed Feb 04, 2009 9:08 pm

Thanks Taggy
I will take a look.

uniquefzrfreak · Post by **uniquefzrfreak** » Fri Feb 06, 2009 8:07 pm

Sorry, can confirm first hand 3TJ ones don't fit. I had a set that I thought were 1WG, but turned out to be 3TJ. Offered them up, but would have been too much work to make them fit. Chopped R6 pipes are a good upgrade, there's a guy on the bay selling ready made sets for around a ton. - You lose the exup though.

sharpey · Post by **sharpey** » Sat Feb 14, 2009 12:29 pm

fzr600 ones fit u just have to space the bottom of the fairings out though as they touch but you can hardly tell when this is done, i have a set on an 3en1, will sell them cheap if they are ok not looked for a while as bike as been left under cover, so dont no if they have rotted or not.

Sean · Post by **Sean** » Sat Feb 14, 2009 7:32 pm

Managed to get the ones off ebay. there are in pretty good nick as well. just got to find the time to fit them.

Exhaust question

Exhaust question

Re: Exhaust question

Re: Exhaust question

Re: Exhaust question

Re: Exhaust question

Re: Exhaust question