3TJ exhaust link pipe alternatives?

[Mike Shelby]

Hi - has anyone ever used a link pipe from another bike cut down or tailored one to fit a 3TJ with a good result?

I was wondering if such as an R6 (5eb) one would fit if cut down a bit - has anyone ever tried?

Open to any suggestions/ideas on this as I've contacted someone on ebay who has them (new) but will only sell them with a silencer - which I don't need.

Alternatively has anyone got a standard battered 3tj end can that I can cut off and make a link pipe from the original?

Thanks

Mike

[Evilchicken0]

I don't know of any others that fit .... but I'd have though 4JH or T'Cat would be closer than R6. An exhaust fabricator could probably make one for you.

[Taggyd]

I've got one that I'm not using. Was fitted to my track bike but no longer have that! Pm me if you're interested.
Cheers

[chrisexup]

Mike, there is also one on ebay today.
I sent you a PM / email about a 3tj with a 600 motor last week, did you get them?

[Taggyd]

That's mine on eBay! :)

[Mike Shelby]

*Taggy - How much do you want for the link pipe please?

*Chris - I've just pm'd you - sorry mailbox was full and was stopping me receiving messages - sorted it now - and interested in your bike

Cheers

Mike

[Pab10]

I had 4jh(micron) and 5eb(akrapovic) mufflers and both are basically the same in term of fitment, i tried to install them on the 3tj, and there are 2 things to work with:
-The link pipes have a reduction where it connects to the header (4jh and 5eb had an smaller diameter header outlet), to fit it you will have to cut the smaller diameter section.
-The bend has more angle than needed, so, to make it fit properly you will have to reduce that angle.