Ott or not ?

[carpman]

Wicked, will buy some now :) you prime it first or anything? So just spray and bake straight away? Job for the weekend for me :)

I cleaned and keyed up the caliper best I could, then gave it all a good spray with brake cleaner to remove all the shit.

Masked up then sprayed in light coats with a heater on it inbetween coats. Left to dry for 24 hours then baked in the oven using the instructions on the can.

Job jobbed

Same way

[Cammo]

Expert job.

Just one thing though, I would buy new disc bolts as old ones have tendency to snap off in the wheel when you torque them up.

Kris

Have a whel with 3 snapped bolts , didnt even get to torquing them up and they had hardly gone tight before they snapped

I find that this usually happens when previous owners have used threadlock on the bolts/wheel threads. I never use it on disc bolts.

[Sunnyday]

A dusting of clear laqure will help protect them after you have polished them, it will keep the oxyigen and slow down any rusting.

[carpman]

Here's the latest pics and it now includes axle pinch bolts and wheel spacers, gonna be ordering new bearings and seals from wemoto tomorrow.





I know axle ain't great but its a lot better than it was
Oh yeah and just to make you laugh after i put the callipers back together and i had torqued them up I noticed 2 little seals sitting on my side oh boulder dash I said now there I was worrying about chipping the paint on the torx's bolts which I didn't do but now I have to undo them again it's bound to be the wrong 1 that I take apart but I was fortunate and I still managed not to chip the paint , cleaned up insides of my forks and calliper mounts just got to get the autosol out and finish them off, gave the wheel a little tcut I really need to get them sprayed/powder coated their looking a little rough but that will have to wait.

[Tim400GB]

Top picture is very cool

[carpman]

She's almost back together now thank god still waiting on pads that I ordered last week from the dreaded flea bay

[Delboy]

Very clean