Clutch Lever Reach too Long

Post by **porndoguk** » Thu Oct 04, 2012 9:31 am

In

Out

Shake it all about

CB 4 · Post by **CB 4** » Thu Oct 04, 2012 9:38 am

HI try ebay item 330803667252 hope that helps see if breaker will include a clutch switch connector will measure the span on my bike so u can compare with the other levers shown reg c

Post by **speedy231278** » Thu Oct 04, 2012 10:40 am

I'm sure that my standard lever is one heck of a lot closer to the bar when in and out than that. I have mine set up so there's not a massive amount of movement required, but that looks more like a switch! I'll never forget the time I got the bike back after a service and the play had been adjusted rather badly. I think in and out were about three fag papers apart. Looked like a right wally when I kept stalling trying to get the bike away from the workshop until I adjusted the cable.... lol

Post by **missis sumner** » Thu Oct 04, 2012 11:03 am

I had the same problems with my NC30 when I first got it. I replaced the standard lever with a shorter Titax adjustable, but it really didn't make an awful lot of difference. I think I've just got used to it now.

CB 4 · Post by **CB 4** » Thu Oct 04, 2012 7:09 pm

Goodevening my lever appears to be about 50mm from bar measured the same way as above photos at its min set up thx craig.

Post by **Morespeedvicar** » Thu Oct 04, 2012 7:32 pm

Cant you just slacken the cable off a bit?

Debbie · Post by **Debbie** » Thu Oct 04, 2012 7:42 pm

Hi, thank you but i've found one Blacks. The lever and bracket off a ZZR600 apparently fits so going to try one of those!

johnnie5 · Post by **johnnie5** » Fri Oct 05, 2012 2:57 am

you could just buy stock vfr750/800 levers that come with a span adjuster

Clutch Lever Reach too Long

Re: Clutch Lever Reach too Long

Re: Clutch Lever Reach too Long

Re: Clutch Lever Reach too Long

Re: Clutch Lever Reach too Long

Re: Clutch Lever Reach too Long

Re: Clutch Lever Reach too Long

Re: Clutch Lever Reach too Long

Re: Clutch Lever Reach too Long